…and not the ones RIM makes, either! This year, the blackberry plants growing wild in our yard along the fences and stream valley seem to have a bumper crop of berries on them. I suspect the plentiful June precipitation had…
Category: Us
A Calligraphy Set We’ve Always had Trouble With
We’ve had this calligraphy set in our store for years, but we’ve never had any success using it. The problem we run into is that the ink does not wet the nibs and flow out properly; instead whatever ink gets…
A Tiny Bird Nest Amidst the Tall Grass
Earlier this week I was picking some wild blackberries that grow along the fences and creek bed at the rear of our property when I ran across this tiny bird nest built on a tussock of tall grass. I only…
Sorting the Sorts
Now that I have the font display matrices in boxes, I have an assortment of sorts matrices to sort out and store. In addition to the sorts I also had a few cardboard boxes of unfiled small caps, odd sizes,…
Father’s day at the Hamilton Mini Maker Faire
Last Sunday (the 21st, that is) we spent the afternoon in Hamilton at the Mini Maker Faire, hosted by the Hamilton Museum of Steam & Technology. The site is a former Victorian-era steam-powered plant for pumping municipal water from Lake…
But then there’s the sorts matrices…
I have my display font matrices in proper boxes now, but I still have mats for symbols, arrows, braces and brackets, ornaments, borders, etc. to sort out and inventory. Most of these were in the loose tray at top left.…
Display matrices all in boxes (finally)
I finally have all my Monotype display matrices, at least the ones I plan on keeping in the long run, in uniform storage boxes. Altogether I have 82 faces in 82 boxes, each box containing between 1 and 5 sizes.…
Tagged with: Sky Shipley
How Not to Make Matrix Blanks
The Lanston Monotype display matrices are essentially rectangles of brass (or aluminum) approximately 1⅛×¾×0.094″ with two corners cut off at an angle. It would seem that the best material to start with would be 1/8×¾″ brass strip, and the first…
Tagged with: Jim Rimmer
Tramming the Mill
In order to get a good finish when milling the top surface of a part, as I will be doing to prepare matrix blanks, it is necessary that the axis of the mill spindle be perpendicular to the surface of…
An Interem Solution to the Pneumatic Valves Problems
This week I’ve been occupied with (finally) putting away all the display mats I bought last year at the Anderson and Skyline matrix auctions. They have been cluttering up the shop since last summer with their variety of packaging. I…
Tagged with: Jim Rimmer
Top