My last post on this subject showed the initial copper plating almost covering the graphite. An hour or two of further plating produced a nice bright copper layer over the entire surface of the rubber mould. The plating was fairly…
Category: Letterpress
Adventures in Matrix Copying – Part 2
My first attempt at making a rubber mould of a Lanston display matrix ended up with a fatal flaw due to an air bubble. I made a second attempt, hoping to avoid repeating this flaw. The instructions for the casting…
Adventures in Matrix Copying
One thing I have wanted to try for a while was the duplication of a Lanston Monotype display matrix. It it probably not worth the trouble to copy an entire font of mats, but it would be useful for replacing…
Another Wayzgoose is History
Last Saturday the 36th annual Wayzgoose was held at the Grimsby Public Library and Art Gallery in Grimsby, Ontario. We were fortunate to have our sale table right next to the front door so we didn’t miss any visitors. Lily…
Last week’s time suck
Last week was March Break, and Audrey and Lily flew to Calgary to visit Granny. I took the opportunity to do a few home improvement projects (replacing a bathroom sink, putting up a knife holder in the kitchen, and installing…
A Bit of Font Casting
I have a short project in the works, and since I don’t have a Monotype Keyboard or a computer interface for the caster, I have to fall back to hand setting some text. I have a few paragraphs that I…
Tagged with: Ian Schaefer
Proof from the March 2nd Casting
My post on this weekend’s casting adventures did not include a proof of the imperfect but useable forme cast in the early evening, so here it is: This was done with rubber based ink, and the gloss of the ink…
March 2nd Casting Session: A Modicum of Success
The first job was to address the problem of the magnetic starter tripping out every few lines. I found online several documents regarding the pulsing nature of the current drawn on the input of a VFD. I think the pulsing…
March 1st Casting Session
This morning I checked the angular alignment of the nozzle on my caster and found that it was off a tiny bit, so I adjusted that. I also reset the nozzle to its proper center position on the assumption that…
February 23rd Casting Session
Last Sunday was another frustrating day of casting. The only way I could get the nozzle to seal even remotely well was to have it clearly out of alignment, so it was moving sideways every time it rose and dropped.…
Top