Category: Documentation

Lubricating Oil for Old Printing Equipment

Many old pieces of printing and typecasting equipment recommend (amongst other products) Mobil Vactra for lubricating some of the sliding surfaces. Locations like journal bearings (where a shaft rotates in a round smooth hole) retain their oil by surface tension.

Now I know…

…why the Monotype manuals say not to raise or lower the pot unless it is molten. They never explained why this could cause any problems, and the pump piston linkage is jointed enough to follow the pot up and down

Sorting the Sorts

Now that I have the font display matrices in boxes, I have an assortment of sorts matrices to sort out and store. In addition to the sorts I also had a few cardboard boxes of unfiled small caps, odd sizes,

Making a Display Matrix, but Which One?

It seems natural for me, as a first project using my new pantograph engraver, to try making a matrix. Rather than designing a whole new family of typefaces (or even a single typeface), I decided to make a single character.

18 Point Mould in Pieces Again

With my test casting using the American display mould set up for 18 points I found that the feet of the type were wider (pointwise) than the heads of the type. This was probably due to dirt being caught between

Making a US Display Mould Spacer—Roughing

I’ve started making an 18-point spacer for one of my US Monotype display moulds per the drawing in my last post. The material I started with was ⅜×¾″ hot-rolled steel because I had a piece handy. The bar was about

US Display Mould Spacer Dimensions

I’ve measured all the spacers I have for US Monotype Display mould blade kits. There are two styles (long and short) which correspond to the style of blade front (thin or thick respectively). This drawing shows both superimposed: There seemed

A Minecraft black hole

Lily has taken a liking to playing Minecraft, and I’ve been sucked into it as well. We have 6 computers networked together here at our home and store, so it made sense to set up a network server so we

Tagged with:

One of my new Monotype books

One of the books I recently acquired from Don Black has the rather bland title Function and Operation of the 15-17 Casting Machine but after reading this book, I see how the subtitles reveal its true importance: Including Supplementary Equipment

Tagged with:
Top