Someone recently asked about serial number locations on Monotype Composition Casters, and I knew I had a sort of list of where these were located. This information turned out to be in a presentation I gave at the 2012 American…
Someone recently asked about serial number locations on Monotype Composition Casters, and I knew I had a sort of list of where these were located. This information turned out to be in a presentation I gave at the 2012 American…
The 2023 American Typecasting Fellowship conference took place over the weekend of April 30th/May 1st 2023 in the area around Portland, Maine.
After one cancellation and one virtual meeting both due to the COVID-19 pandemic, the American Typecasting Fellowship (ATF) will be holding its first in-person conference since the August 2018 conference hosted by M&H Type in San Francisco. This year’s event…
Sunday August 26th was the wrap-up day for the conference. In the afternoon there was a barbecue and open house hosted by Patrick Reagh Printers in Sebastopol, about an hour’s drive north of San Francisco. Unfortunately my flight home departed…
The first day proper of the 2018 ATF conference consisted of a series of presentations given in the gallery space at Arion Press. The day started off with a continental breakfast, a Welcome and general comments and announcements, then on…
Why “Day Zero”? The American Typefounding Fellowship conference proper started on Friday, August 24th, but the day before that had technical sessions, where we got to see how M&H Type run their Monotype Composition casters. I attended the afternoon session,…
On my return flight from the ATF conference in San Francisco I spotted two interesting views out of my airplane window (facing South). The first was an interesting landform in Wyoming: The Killpecker Sand Dunes are formed from an old…
Tomorrow I’ll be flying to San Francisco for the 2018 American Typecasting Fellowship (ATF) conference, hosted this year by M&H Type and the Arion Press. I expect most of the usual gang to be there, with presentations about old systems…
My last post about this project was over a year ago, wherein I mentioned that I had purchased the aluminum stock to make the main parts of the valve unit. A lot has happened since then, to the point where…