Three years ago I attended SoOnCon 2012 hosted by Diyode in Guelph. The “badge” for this event was an Arduino Uno board, with Codeshield, a shield of general-purpose sensors and actuators, all mounted with a battery pack on a custom-made…
Category: Kevin
My tomato plants are dying (again)
I’m finding that the tomato plants in my vegetable garden, which have been growing so well up until now, are doing the same thing they’ve done for the past three or four years: They suddenly wilt, sicken, and die. What…
It’s Getting Real
I actually went out and purchased some aluminum stock for making the computer control valve for my Monotype. That’s a piece of 1″ aluminum square bar which will make the mouthpiece that fits against the air holes in the caster’s…
A Calligraphy Set We’ve Always had Trouble With
We’ve had this calligraphy set in our store for years, but we’ve never had any success using it. The problem we run into is that the ink does not wet the nibs and flow out properly; instead whatever ink gets…
A Tiny Bird Nest Amidst the Tall Grass
Earlier this week I was picking some wild blackberries that grow along the fences and creek bed at the rear of our property when I ran across this tiny bird nest built on a tussock of tall grass. I only…
Sorting the Sorts
Now that I have the font display matrices in boxes, I have an assortment of sorts matrices to sort out and store. In addition to the sorts I also had a few cardboard boxes of unfiled small caps, odd sizes,…
But then there’s the sorts matrices…
I have my display font matrices in proper boxes now, but I still have mats for symbols, arrows, braces and brackets, ornaments, borders, etc. to sort out and inventory. Most of these were in the loose tray at top left.…
Display matrices all in boxes (finally)
I finally have all my Monotype display matrices, at least the ones I plan on keeping in the long run, in uniform storage boxes. Altogether I have 82 faces in 82 boxes, each box containing between 1 and 5 sizes.…
Tagged with: Sky Shipley
How Not to Make Matrix Blanks
The Lanston Monotype display matrices are essentially rectangles of brass (or aluminum) approximately 1⅛×¾×0.094″ with two corners cut off at an angle. It would seem that the best material to start with would be 1/8×¾″ brass strip, and the first…
Tagged with: Jim Rimmer
Tramming the Mill
In order to get a good finish when milling the top surface of a part, as I will be doing to prepare matrix blanks, it is necessary that the axis of the mill spindle be perpendicular to the surface of…
Top