Once the operating rod for the paper tower is adjusted, there are four adjustments left, all affecting the Air Bar 2G, Pressure Bar 3G, and air feed. Two of the adjustments are on the Connecting Bar 4G that links the…
Category: Equipment Acquisition, Repair, and Maintenance
Monotype Paper Tower adjustments
The book Casting Machine Adjustments provides procedures for adjusting the Paper Tower, but I find that these adjustments are given in the wrong order (later adjustments can affect earlier ones) and some of the adjustments are rote settings which may…
One more home-made part for the Monotype
While refurbishing the paper tower for my Monotype caster I found that one of the pivot pins (part 16G, on which the locking pawl pivots) was slightly bent, and was nearly impossible to straighten properly. The bend was hard to…
Monotype Ribbon Feed Mechanism
The other part of my caster’s paper tower that received a good cleaning is the ribbon feed mechanism. The ribbon itself is moved by two sprockets whose teeth engage in holes along either side of the ribbon. These sprockets are…
Monotype Quadding Counting Wheel
This post provides a detailed view of one of the mechanisms in the Monotype paper tower. When the Quadding mechanism is engaged a notched wheel on the front side of the paper tower turns one position per cycle, and the…
Chasing Monotype air leaks
After refurbishing both air pin blocks and replacing the paper tower air connector on my Monotype, I tried another dry run with the ribbon I had. I was finding that there still seemed to be substantial air leaks, which sounded…
A Composing Stick Rack for Richmond Hill
As part of the general clean-up taking place over the past few months at the shop of the Book Arts Guild of Richmond Hill, I found that we did not have any good place to store our collection of composing…
A Monotype aftermarket mod
Up until recently I have used my Monotype without its paper tower for font and sorts casting. What I found frustrating in doing so was manually positioning the matcase. This is a minor setup nuisance when casting from display mats…
Monotype Pneumatics – Front Pin Block R&R Part 3
All the parts from the front pin block have been cleaned and repaired, and so it is time to reinstall them.
Another home-made Monotype part
While refurbishing the front pin block on my Monotype caster I observed the wear on both the jaw pin guide rod and its support caused by having the rod fitting loosely in the support. The end of the rod is…
Top