After finishing one side of the extended-stroke piston rod for my Monotype, I took apart all the work holders and gave the mill a bit of a cleaning. The rod has now been clamped down to the milling table with…
Category: People and Organizations
Monotype piston rod milling half-completed
With the flats completed on the piston rod, it was time to mill the groove by which the piston is raised and lowered. This took quite a bit of time as I had the mill running at very conservative feed…
Finally working on the Monotype piston rod again
It has been a while but I finally got around to working on the extended-stroke piston rod for my Monotype caster’s pump tonight. A while ago I had drilled and tapped the end hole for the handle. I was fortunate…
A little more cleaning on the Monotype Pump
Finishing the new extended-stroke piston rod is taking a little longer than planned, so in the meantime I decided to clean the piston and pump body lever mechanism. This is what transmits the pump spring pressure to the pump proper.…
Mulberry maintenance
As part of trying to get better fibre from my mulberry plant, this year I am trying to prevent the original shoots from getting any side branches. This turns out to require some persistence at pulling off the suckers—the new…
New Monotype Pump Spring Rod (sort of)
After realizing that I could not make a new pump rod for my Monotype caster on my lathe (the lathe bed was not long enough), I considered several ways to get around this problem. As it turns out the solution…
Papermaking for the Dundee Pottery Arts Camp
Tomorrow we will be hosting a two-hour papermaking session for kids in collaboration with the Arts Camp organized by Dundee Pottery. Hiding out of sight is also a supply of glitter and other decorations to add to the paper.
Tagged with: Dundee Pottery
Finished paper from the Washi Workshop
Here are some photos of paper made at our recent Washi Workshop. My habit is to scoop new pulp on the near side and throw off on the far side, so these two flaws always appear on the same edges…
Monotype Pump Latch R&R Completed
The reconditioning of the pump latch for my Monotype caster is now complete. I found some donors for the missing screws in my parts stock. There were two of the actual latch trigger assemblies there (but not the rest of…
So much for a part being easy to make…
I thought the new spring rod I have to make for my Monotype pump would be relatively easy to do, after all, it is just a length of 5/8″ round rod threaded at both ends. The problem is that my…
Top