I actually went out and purchased some aluminum stock for making the computer control valve for my Monotype. That’s a piece of 1″ aluminum square bar which will make the mouthpiece that fits against the air holes in the caster’s…
Category: Caster Computer Control
An Interem Solution to the Pneumatic Valves Problems
This week I’ve been occupied with (finally) putting away all the display mats I bought last year at the Anderson and Skyline matrix auctions. They have been cluttering up the shop since last summer with their variety of packaging. I…
Tagged with: Jim Rimmer
More information on Matrix pneumatic valves
This week I was having another look at the pneumatic solenoid valves I want to use to run my Monotype from a computer. I was somewhat disappointed that the valves I had were the Normally Open (N/O) type and designed…
Measuring air valve spring strength
In addition to poor flow when open, the other shortcoming of my stock of surplus Matrix pneumatic valves is poor sealing (leakage) when operated in NC mode, where the shutter spring is the only force holding back the flow of…
Measuring air valve shutters
Looking deeper into the poor airflow observed on my stock of surplus Matrix pneumatic valves, I did a subjective measurement of the airflow on each port, on a scale from 0 to 5, using a 20PSI supply. At zero, the…
Pneumatic valves for Monotype computer control
The most expensive and bulky aspect of making a system for computer control of the Monotype composition caster is the pneumatic solenoid valves. You need 31 valves, and they typically cost $30-$50 each. They are generally large enough that they…
Top