One thing I would like to be able to do with my Monotype Composition Caster is to cast spacing and rule. There is a kit of parts required to make the change-over, and I now have most of the necessary…
Year: 2015
18 Point Mould in Pieces Again
With my test casting using the American display mould set up for 18 points I found that the feet of the type were wider (pointwise) than the heads of the type. This was probably due to dirt being caught between…
Yesterday’s dumb move
In my last post I mentioned problems with flash and squirts around the seal between the matrix and the display mould. I have since added a comment alluding to the probable cause of this problem: Forgetting to reinstall the link…
Making a US Display Mould Spacer—Finishing and Testing
I became so involved in finishing the 18 point display mould spacer that I never took any pictures of the process. Using a flat file, three diamond sharpening “stones” and a wood block coated with polishing compound, I finished the…
Making a US Display Mould Spacer—Roughing
I’ve started making an 18-point spacer for one of my US Monotype display moulds per the drawing in my last post. The material I started with was ⅜×¾″ hot-rolled steel because I had a piece handy. The bar was about…
US Display Mould Spacer Dimensions
I’ve measured all the spacers I have for US Monotype Display mould blade kits. There are two styles (long and short) which correspond to the style of blade front (thin or thick respectively). This drawing shows both superimposed: There seemed…
Endbands (Headbands)
I just added a new Page to the static content of our site showing samples of the endbands (headbands) that we sell.
Measuring US Display Mould Spacers
In order to make an 18 point spacer for use in a US Monotype Display Mould, I first have to determine the dimensions required. I set up a spreadsheet for recording the data and measured the dimensions of all the…
Up, Down, What’s the difference?
My recent post about setting up to cast 18 point display type got up and down mixed up. When casting 18 point on an English mould with an American display mat holder, the mat must be lowered, not raised as…
Bald eagle sighting near Kitchener?
On Tuesday I was driving along highway 401 where it crosses the Grand river in south Kitchener when I saw the silhouette of a very large bird flying south of the highway. I only saw it for a second or…
Top