I have completed my five cases for holding Monotype composition matcases. Despite my efforts to get the grooves uniformly deep, I found after assembling the cases that some grooves were too shallow. This meant that I spent a lot of…
Year: 2014
Cases for Monotype Composition Matrices
I returned from picking up my display matrix purchases with several matcases of composition mats as well, and so far I have no good place to keep them. The few I had have been stored in the same drawer as…
Things will be abuzz for me Saturday
This Saturday I’ll be attending a one-day workshop on beekeeping. Audrey saw a notice posted at KwartzLab about upcoming workshops, and, since I clearly don’t have enough hobbies to keep me busy, I thought I would give it a go.…
Adventures in Matrix Copying – Part 3
My last post on this subject showed the initial copper plating almost covering the graphite. An hour or two of further plating produced a nice bright copper layer over the entire surface of the rubber mould. The plating was fairly…
Defective Column Pusher Spring Box Fixed
A while ago I made a new spring for the operating lever latch on my Monotype caster, based on specifications passed to me by Bill Welliver. The problem was that when the line length was incorrect, the column pusher was…
Challenge Proof Press Lockup Bar Working
My previous post described my confusion as to how the lockup bar for my Challenge proof press works. As I mentioned in a comment to that post, I found my answer online in US patent number 3288062 which shows how…
Challenge Proof Press Lockup Bar
One part of my Challenge MA15 proof press that I cannot figure out is the lockup bar, used as a quick way of clamping the type in position on the bed. The bar has a locking lever which turns an…
A Trip to West Virginia
The display matrices I had purchased in the recent Anderson auction were heavy enough that it would have cost several hundred dollars to ship them. Instead I took a couple of days to drive to Terra Alta, WV, to visit…
Tagged with: Rich Hopkins
Adventures in Matrix Copying – Part 2
My first attempt at making a rubber mould of a Lanston display matrix ended up with a fatal flaw due to an air bubble. I made a second attempt, hoping to avoid repeating this flaw. The instructions for the casting…
It’s Not Dead Yet!
This post was written on January 31st, but for some reason I forgot to actually publish it! This year’s mulberry branch harvest has been sitting in a bucket of water to keep it fresh, but it has also been sitting…
Top