The last task left for Unit Shift was to install (what I call) the buffer valve. I use this term because its purpose is to store the Unit Shift selection (on or off) from the end of the ribbon read…
The last task left for Unit Shift was to install (what I call) the buffer valve. I use this term because its purpose is to store the Unit Shift selection (on or off) from the end of the ribbon read…
In my next task of getting the paper tower operational on my Monotype composition caster, I have started cleaning and lubricating the various pneumatic control valves. The first one I did is a combination of the Unit Shift control valve…
I’ve started tracing all the pneumatic plumbing on my Monotype caster, and at least now I’ve identified all the various control valves hanging off the table apron. This may be old news to any Monotype pros who may be out…
Inspired by my recent attendance at Monotype U 8, and given that I kept the ribbon I had punched on the keyboard there, I have decided to reinstall the paper tower which I had removed from my Monotype caster when…
The last week of August I will be heading to the mountains of West Virginia to attend Monotype University 8. This is a week-long intensive course on the operation of the Monotype Composition caster with emphasis on composition casting. This…
This is the culmination of a long three-pronged refitting of the pump on my Monotype composition caster. The three parts were disassembling, cleaning, and reassembling the pump head mechanism, refitting a pump latch mechanism scavenged from another caster, and making…
The extended-stroke piston rod I was making for my Monotype caster is now finished. Now that it is off the mill, cleaned up, and has its handle put on it looks so much like it could have been a factory-made…
After finishing one side of the extended-stroke piston rod for my Monotype, I took apart all the work holders and gave the mill a bit of a cleaning. The rod has now been clamped down to the milling table with…
With the flats completed on the piston rod, it was time to mill the groove by which the piston is raised and lowered. This took quite a bit of time as I had the mill running at very conservative feed…
It has been a while but I finally got around to working on the extended-stroke piston rod for my Monotype caster’s pump tonight. A while ago I had drilled and tapped the end hole for the handle. I was fortunate…